Aspire - Kit Pod Vilter S
Introducing the Vilter S Pod Kit from Aspire !
The Vilter S Pod Kit offers you a little revolution, indeed, this pod is equipped with a disposable drip-tip that imitates the filter of a traditional cigarette, however a classic delrin drip-tip is also provided.
Compact and lightweight, the Vilter S Kit Pod will fit in your hand in a stylish way.
The Vilter S is powered by a built-in 500 mAh battery and has a 0.69" OLED display.
It charges quickly with its USB-C cable and the Vilter / Vilter S 1600 mAh Powerbank (sold separately) will give you even more battery life.
This kit is equipped with a cartridge that can accommodate up to 2ml of e-liquid, moreover this cartridge is equipped with a built-in resistor of 1 Ohm.
To change the resistor you will have to change the entire cartridge.
With the Vilter S the filling is done from the bottom by simply removing a small cap, nothing could be easier !
The Vilter S Kit is used in MTL (tight) draw, just suck to vaper no need to press a button.
Remember to change your cartridge regularly.
This will depend on how often you use it, but approximately every fortnight it should be changed or when you notice an unpleasant taste.
Secure HTTPS TRANSACTIONS
FREE SHIPPING from CHF 50.
CONTACT US by phone and email.
Kit Pod Vilter SThe Kit Pod Vilter S has a disposable drip-tip that mimics a traditional cigarette filter, however a classic delrin drip-tip is also provided. Compact and lightweight, the Kit Pod Vilter S is powered by a built-in 500 mAh battery and has a 0.69" OLED display. The Vilter S Pod Kit charges quickly with its USB-C cable and the Vilter / Vilter S 1600 mAh Powerbank (sold separately) will give you more battery life if you want it. There is no need to adjust the power, the Vilter S automatically adjusts the power. Simply select one of the three modes: A (automatic / auto draw), B (with switch) or AB (automatic / auto draw or with switch). The powerful ASP chipset provides safety in case of overheating, short circuit, overload, low voltage, reverse polarity and over discharge. The cartridge with integrated 1 Ohm resistor can hold 2ml of e-liquid. To change the resistor you will have to change the entire cartridge. With the Vilter S the filling is done from the bottom by simply removing a small cap. The Vilter S Kit is used in MTL draw (tight), simply suck to vaper no need to press a button. |