Falcon Infinity 55K Coil + Luv 66 E-Liquids JNR

Falcon Infinity 55K resistor with Luv 66 e-liquids

Is your resistor starting to show signs of wear? The JNR Falcon Infinity 55K Resistor + Luv 66 E-liquids Packallows you to continue using your device without having to buy a whole new kit.

It includes all the consumables you need to get your Falcon Infinity 55K up and running again: a brand-new 0.6 ohm mesh resistor and two 10 ml bottles of Luv 66 e-liquid with nicotine salts, totalling 20 ml.

Simply keep the battery and the 10 ml cartridge from your original kit, replace the old resistor, then refill the tank.

When it comes to flavours, Luv 66 takes its inspiration from a classic in the world of shisha, combining juicy, slightly tangy citrus fruits with the tropical character of passion fruit. A moderate freshness rounds off the blend, adding vibrancy without overpowering the fruit.

Important: this pack does not contain a battery or cartridge. It is intended for users who already own a Falcon Infinity 55K and have kept its 10 ml tank.

Give your Falcon Infinity 55K a new lease of life

The Falcon Infinity 55K operates on a particularly practical principle: when the resistor reaches the end of its life, there is no need to replace the entire device.

The 1000 mAh rechargeable battery and the 10 ml refillable cartridge from the original kit are retained.

Only the consumables are replaced.

This Luv 66 pack therefore provides a new 0.6 ohm mesh resistor as well as the two bottles of e-liquid needed to continue using your Falcon Infinity 55K.

Simply remove the used resistor from your cartridge, fit the new resistor, fill the tank with the supplied Luv 66, and your Falcon Infinity is ready for another cycle of use once the resistor has been primed.

As the 10 ml cartridge is not included, please ensure you keep the one supplied when you purchased your Falcon Infinity 55K kit.

A 0.6 ohm mesh resistor for the Falcon Infinity 55K

The Falcon Infinity 55K system uses a removable 0.6 ohm mesh resistor.

Unlike a cartridge where the resistor is permanently integrated into the tank, the Falcon Infinity allows you to replace only the resistor when it reaches the end of its life.

This design therefore allows you to continue using the same 10 ml cartridge.

Mesh technology provides an extended heating surface to promote even vapourisation of the e-liquid and consistent flavour delivery.

With Luv 66, it helps to preserve the contrast between the zesty citrus notes, the tropical notes of passion fruit and the freshness that characterises the blend.

A resistor designed to accompany two bottles

The 0.6-ohm Mesh resistor included in this pack is designed to be used with two 10 ml bottles of Luv 66, totalling 20 ml of e-liquid.

The first bottle is used to fill the 10 ml cartridge completely. Once the tank is empty, the second bottle can be used to refill it.

This gives you a complete set comprising the resistor and the two bottles needed to start a new cycle.

However, the actual lifespan of a resistor may vary depending on frequency and conditions of use. A significant reduction in flavour, less generous vapour production or the persistent presence of an unusual taste may indicate that the resistor needs replacing.

How do you replace the resistor on the Falcon Infinity 55K?

Start by removing the cartridge from your Falcon Infinity 55K, then carefully remove the used resistor from the tank.

Next, fit the new 0.6 ohm mesh resistor into place, ensuring it is correctly positioned.

Open the side flap of the cartridge and fill the tank with the Luv 66 e-liquid supplied. As the cartridge’s maximum capacity is 10 ml, one bottle is enough for a full refill.

Carefully close the flap after refilling.

When a new resistor has just been fitted, it is important to wait around 10 minutes before vaping.

This allows the cotton inside the resistor to soak up the e-liquid properly and reduces the risk of heating a resistor that is not yet sufficiently saturated.

Luv 66: a timeless classic inspired by shisha flavours

With Luv 66, JNR draws inspiration from a fruity combination that has become particularly popular in the world of shisha bars.

The recipe centres primarily on citrus fruits. Juicy and slightly tangy, they provide a lively, invigorating initial flavour that immediately gives the blend its character.

The passion fruit then takes over with its much more exotic profile. Its tropical flavour adds more roundness whilst retaining a hint of tartness that pairs naturally with the citrus fruits.

The appeal of Luv 66 lies precisely in this balance: the citrus fruits give the recipe a zesty kick, whilst the passion fruit brings out its more tropical and generous side.

A moderate coolness complements the fruits and provides an extra refreshing sensation without turning Luv 66 into a heavily frozen blend.

The result is a fruity, exotic, slightly tangy and subtly cool e-liquid, with a level of sweetness characteristic of ‘puff-style’ blends.

Two 10 ml bottles of Luv 66 with Nicotine Salts

In addition to the 0.6 ohm Mesh Resistor, this pack contains two 10 ml bottles of JNR Luv 66 e-liquid, totalling 20 ml.

Each bottle is formulated with 20 mg/ml of nicotine in the form of nicotine salts.

With a Falcon Infinity cartridge holding 10 ml, each bottle is sufficient for a full refill of the tank.

You therefore have two refills of Luv 66 to go with the new Resistor supplied in the pack.

A pack of consumables without a battery or cartridge

This product is not a new, complete Falcon Infinity 55K kit.

It is a replacement pack intended for users who already own the JNR Falcon Infinity 55K device.

The rechargeable battery is not supplied and the 10 ml cartridge is not included. You must therefore reuse these two components from your original kit.

The pack contains only the 0.6-ohm mesh resistor and the two 10 ml bottles of Luv 66.

This distinction is particularly important regarding the tank: do not throw away your tank when your resistor reaches the end of its life, as you will need it to install the new resistor.

Why choose the Falcon Infinity 55K resistor with Luv 66?

This pack allows you to continue using your Falcon Infinity 55K by simply replacing the necessary consumable parts.

You keep the rechargeable battery and the 10 ml cartridge from your original kit, then replace the used resistor with the new 0.6 ohm mesh resistor supplied.

The two bottles of Luv 66 then provide you with 20 ml of e-liquid containing nicotine salts at a strength of 20 mg/ml.

You’ll thus have your Falcon Infinity 55K back with a new resistor and a flavour blend combining citrus, passion fruit and a moderate freshness, inspired by a classic from the world of shisha.

And once this new cycle is complete, you can choose to stick with Luv 66 or select another flavour from the range of consumables compatible with the Falcon Infinity 55K.